The calculations you actually reach for on the shop floor, straight in the browser. No sign-up, works on a phone.
The maths is the same engine that drives LATHE-NC.
Programmed X/Z coordinates and the offset for chamfers, tapers and corner radii. Stop working out "0.47 for an R0.8" on a calculator every time.
Open the calculator → ⏱️RPM, feed rate and cycle time from cutting speed and diameter, with starting speeds by material. Japanese interface for now.
Open the calculator → 📏Taper angle and ratio from the large and small diameters and the length, plus the diameter at any position. Japanese interface for now.
Open the calculator →Want a calculator that is not here? Tell me on X (@lathe_nc_works).
Load a DXF and get G-code with nose radius compensation already applied, plus the simulation.
A CAM built only for turning, running in the browser. The beta is free.
With LATHE-NC you pick the tool and the G-code comes out with nose radius compensation included.
No install, no sign-up. The beta is free.